Ht-instruments MACROTEST 5035 Manual do Utilizador descarregar pdf (Página 11)

MACROTEST 5035

EN - 10

4.1.1. Mode "CAL"

1. Select mode CAL by means of the FUNC key.

2. Connect the black and blue cables to the instrument input terminals B1 and B4

respectively:

B2 B3

Connection of instrument terminals during calibration procedure.

3. If the cables supplied with the instrument are not long enough for the measurement you can

extend the blue cable.

4. Connect the crocodiles to the cable terminals.

5. Short-circuit the measuring cable ends making sure that the conductive parts of the

crocodiles make a good contact to each other (see previous picture).

6. Press the START/STOP key. The instrument carries out the calibration.



At the end of the test

the result is stored and

used as OFFSET (that

is to say that it is

subtracted from any

continuity test carried

out) for all the

subsequent

measurements until a

new calibration is

carried out.

CAL LOWΩ

0.00 Ω

203 mA

This screen is displayed for only 2 seconds

then the instrument emits a double sound

signal (indicating that the calibration is

completed) and displays the default screen

relative to the LOWΩ test under AUTO mode.

NOTE: The instrument effects the calibration of cables with resistance lower of 5Ω.

Message CAL:

means that the

instrument was

calibrated; this

symbol remains

on the display

for any further

measurement

even though the

unit is switched

off and on again.

Current supplied

by the instrument

during the

calibration

rocedure.

START

STOP

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 79 80

Comentários a estes Manuais

S.imoim.net 04 Dec 2024 | 14:11:18

Text and images you copy will automatically show hereText and images you copy will automatically show here

Ht-instruments MACROTEST 5035 Manual do Utilizador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Ht-instruments MACROTEST 5035