Ht-instruments PVCHECK Manual do Utilizador descarregar pdf (Página 52)

PVCHECK

EN - 50

6.6. LIST OF DISPLAY MESSAGES

MESSAGE DESCRIPTION

Function not available The selected function/characteristic is not available

Data not saved The instrument was not able to save the data

Wrong date Set a correct system date

RADIO transmission error The instrument does not communicate via RF with external units

SOLAR-02: Firmware incorrect Inconsistent SOLAR-02 FW. Update firmware.

Firmware incorrect Unsuitable instrument FW. Update firmware.

Error 4: contact service Internal instrument error

Database full The number of modules added to the internal DB is > 30

Module already added The name of the module has already been added to the DB

Memory full Instrument memory full upon pressing the GO key

Error: Vmpp >= Voc Check module settings inside DB

Error: Impp >= Isc Check module settings inside DB

Error: Vmpp * Impp >= Pmax Check module settings inside DB

Error: Alpha too high Check module settings inside DB

Error: Beta too high Check module settings inside DB

Error: Gamma too high Check module settings inside DB

Error: Toll too high Check module settings inside DB

Wait data analysis

Download data from SOLAR-02 and wait for the result of PV efficiency

test

Download error Contact service department

Error while saving Problems with the access to memory area

Remote unit undetected The instrument does not detect any remote unit SOLAR-02

Unable to perform analysis Problems with the data downloaded from SOLAR-02. Check settings.

Data unavailable Generic error. Repeat the test.

Negative voltage Check the polarity of the instrument’s input terminals

Low voltage Check the voltage between input terminals P and N

Vin > 1000 Voltage between input terminals > 1000V

Wrong no. of modules. Continue? Set no. of modules inconsistent with measured Voc

Ref. cell temp. exceeding limits Temperature measured by reference cell too high

Cell temp. undetected

(ENTER/ESC)

Measurement not carried out on module cell

Low battery Low battery charge. Insert new batteries.

Please wait for cooling… Instrument overheated. Wait before resuming the test.

Irradiance too low Irradiance value lower than the minimum threshold set

NTC Error Internal NTC efficiency jeopardized. Contact service department

Isc current too high Measured Isc current > 10A

Current < Lim Current between P and N lower than the minimum detectable value

EEPROM error: contact service Internal instrument error

FRAM error: contact service Internal instrument error

RTC Error: contact service Internal instrument error

RADIO error: contact service Internal instrument error

FLASH error: contact service Internal instrument error

IO EXP error: contact service Internal instrument error

Voltage > limit Voltage between terminals E and C > 10V

Label already assigned Change the numeric reference of the marker associated with the measur

Isc current < Lim

Isc current lower than the minimum detectable value. Contact service

department

CAUTION: internal short-circuit Contact service department

CAUTION: blown fuse Contact service department

Reset calibration. Press ENTER.

Resistance value of input cables > 2

Calibration not OK Calibrated resistance value > measured resistance

Error: Isc offset measurement Internal instrument error

Rcal > measured R Calibrated resistance value > measured resistance

CAUTION: AC voltage at P-N

terminals

Presence of AC input voltage

Wait for condenser discharge Wait for discharge of tested object after insulation

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 67 68

Comentários a estes Manuais

Sem comentários

Ht-instruments PVCHECK Manual do Utilizador Página 52

Comentários a estes Manuais

Manuais e produtos relacionados com Ferramentas Ht-instruments PVCHECK